Meco Matek F405-Std Betaflight Stm32f405 Flight Controller+matek Fchub-6s Hub Power Distribution Board For Rc Drone

Matek F405-STD BetaFlight STM32F405 Flight Controller + Matek FCHUB-6S Hub Power Distribution Board Specification: Matek F405-STD (user manual): Brand: Matek Systems Item name: Flight Control Board Size: 36x36mm Mounting hole: 30.5mm Weight: 7g MCU: 168MHz STM32F405RGT6 IMU: 32K ICM20602 gyro/accelerometer (SPI) Baro: BMP280 (I2C) OSD: BetaFlight OSD w/ AT7456E chip Blackbox: MicroSD card slot (SD/SDHC) VCP, UART1, UART2, UART3, UART4, UART5 Built in inverter for SBUS input (UART2-RX) PPM/UART Shared: UART2-RX SoftSerial on TX2, S5 or S6 optional Camera control on S6 or DAC optional Smartaudio & Tramp VTX protocol supported Battery Voltage Sensor: 1:10 Current Sensor: No (FCHUB-6S, FCHUB-VTX, FCHUB-W option) BEC 5V: No (FCHUB-6S, FCHUB-VTX, FCHUB-W option) LDO 3.3V: Max.300mA I2C1 SDA & SCL: Yes WS2812 Led Strip : Yes Beeper : Yes RSSI: Yes Matek FCHUB-6S (user manual): Brand Name: Matek Model: FCHUB-6S Item Name: Power Distribution Board Built-in Current Sensor Size: 36x36mm 30.5x30.5mm Hole Mounting M3 Weight: 8.5g BEC Output: 5V & 10V 5V BEC Output: - Designed for RC Receivers, Flight Controllers, OSD and Servos. - DC/DC synchrous buck regulator - Voltage: 5.0V (4.9-5.1)DC - Current: 1.5A (Max. 2.0A 10S/minute) - Short-circuit tolerant ( 2 Seconds/minuate) 10V BEC Output: -Designed for VTX or FPV Camera - Voltage: 10.0V (9.8-10.2) DC - Current: 1.5A ( Max. 2.0A 10S/minute) - Short-circuit tolerant ( 2 Seconds/minuate) - 10V can be used to power cameras labeled as 12V. - The 3S Lipo input voltage should be 11V plus. Current Sensor Module - Max. Range: 184A - 3.3V ADC - Scale the output voltage to milliamps ( 1/10th mW/A): 179 Package included: 1x flight control board 2x 0.5mm*16Pin 5cm Flexible Flat Cable 4x M3 Anti-vibration Standoffs 1x FCHUB-6S PDB Board 1x bag of screws