Eachine1 Lantian 8 X Ws2812b Driving Led Lights Board Strip Built-In Full-Color For Naze32 Cc3d

Lantian 8 x WS2812B Driving LED Lights Board Strip Built-in Full-Color For NAZE32 CC3D Lantian 8 x WS2812 Built-in Full-Color Driving LED Lights Board NAZE32 CC3D Available Description: WS2812B is the second generation with the built-in IC and 5050RGB lamp bead type with four feet.WS2812B's feet are less than WS2812 with 6 and the circuit is more conciseIt. It can be used for Naze32, CC3D flight control and can show the flight control lock / unlock, left aileron, brake, throttle, alarm and other status. Feature: - LED:5050 Package RGB full color highlighting WS2812B lamps*8 - Voltage:5V(4-7V) - Size:51*10mm - Port:Digital - Platform:AVR, Arduino,Naze32/CC3D Flight Control(Refurbish to be CleanFlight) - 5050 Highlight LED,Built-in control chip.It can control one or more LED with just only one IO port. - Signal can Stable display and not cumulate in distortion with the Chip built-in circuit. - Three primary level 256 can adjust brightness. - 160000 color image display the effect.Not less than 400 HZ/S scanning frequency. - Serial interface level can complete the data through a signal receiving and decoding. - Highlight LED, high light color brightness uniformity. - There are interfaces at both ends(DIN DOUT).They can be concatenated. Remark: - It need to refurbish CleanFlight and use PPM receivers when used in Naze32 or CC3D flight control. - CleanFlight supports up to four lights, namely 32 WS2812B lamp beads. - CC3W need Refurbish to be CleanFlight. - Use PPM/SBUS receiver,PWM Receiver mismatch. - Only match RC Quadcopter. - Options election in CF assistant software:PPM Receiver,then check LED_STRIP - Finally into the CF assistant software LED Strip Page Setup various states Package Include: 1 x Full-Color Driving LED Lights Board