Holybro TekkoS 4 in 1 30A BLHeli_S ESC Current Sensor + Kakute F4 V2 Flight Controller For RC Drone

Holybro TekkoS 4 in 1 30A BLHeli_S ESC Built-in Current Sensor + Kakute F4 V2 Flight Controller OSD For RC Drone FPV Racing Items Descriptions Features Holybro Kakute F4 V2 Flight Controller Item name: Kakute F4 V2 MCU: STM32F405RGT6 32-bit processor IMU: ICM20689 (SPI) Barometer: BMP280 USB VCP Driver (all UARTs usable simultaneously; USB does not take up a UART) 5 hardware UARTS (UART1,3,4, 5, 6) Supports serial receivers (SBUS, iBus, Spektrum, Crossfire) only. PPM and PWM receivers are not supported. 128 Mbit Dataflash chip for Blackbox logging. Dimensions: 35x30x8mm (includes USB in height) Mounting holes: Standard 30.5mm square to center of holes Weight: 7g Additional UART (UART 4) added to support serial camera communication such as to RunCam Split. Additional UART (UART 5) added to support ESC telemetry such as from BLHeli_32 and KISS. Through-hole solder pads instead of flat pads for more secure soldering especially for beginners. Barometer sensor on board allows altitude hold mode. I2C pad available for certain external sensors. Supports Betaflight and Cleanflight. Betaflight OSD. Soft-mounting built in. New high-performance / low-noise / high sensitivity IMU. ICM20689 with 6-axis gyro and accelerometer. Can run at up to 32 kHz. 2 oz. copper PCB allows up to 120A maximum continuous current. Dedicated bootloader button for easy firmware flashing. Low-profile design fits into even very compact frames. Input voltage 7v to 42v. Power the board directly from the flight pack, up to 6S (on "B+" pad only). Automatic voltage monitoring. Filtered voltage output for clean, noise-free video. Supports BLHeli pass-through for easy ESC upgrade and configuration. Holybro TekkoS 4 in 1 30A BLHeli_S ESC Item name: TekkoS 4 in 1 30A BLHeli_S ESC Con. Current: 30amp continuous draw per motor Peak Current: 40amp BEC: no Lipo input: 3-6S MCU: BB21 Firmware: 48Mhz Runs BLHELI_S J_H_xx firmware Mounting hole spacing: 30.5mm x 30.5mm BlHeli_S D-Shot ready Built in current sensor Connector to flight controller Current and voltage sent to flight controller Easy install High-quality components Supports damped light NO external capacitors needed Package included: 1 x Kakute F4 V2 flight controller 2 x vibration-isolating foam 1 x FPC 1 x TekkoS 4-in-1 30A ESC 1 x 8pin JST 1mm pitch 70mm cable