Meco Ewrf E7092tm 5.8g 48ch 25mw/100mw/200mw/off Power Adjustable Aio Vtx Fpv Transmitter Support Sbus

EWRF e7092TM 5.8G 48CH 25mW/100mW/200mW/OFF Power Adjustable AIO VTX FPV Transmitter Support SBUS Specifications Model: EWRF e7092TM Frequency: 5.8G 48CH Transmitting Power : 25mW/100mW/200mW/OFF(Pitmode) Power supply : DC72 -24V(1S) Supply current : 120mA(25mW)/160mA(100mW)/220mA(200mW) Weight : 3.1g(Including antenna weight 1g)4 g Standard size:24.0x24.0mm Mounting holes:20x20mm Main Features Adjustable 4 modes:25mW/100mW/200mW/OFF Betaeltflight/Cleanflight OSD configuring Support SBUS configuring parameter Clean powerup and channel switching without interference to others Miniature and light weight design User Guide 1. Setting After power on, the digital display shows the following three parameters in turn: channel, band and power.Press and hold the button until the red dot appears on the right bottom of the digital display, which can be entered into the parameters setting. When the digital display shows the Arabic numerals for the channel (1-8),press the button can select the channels. Press and hold the button again,the digital display will shows the alphabet for band(A-b-c-d-E-F) press the button can select the bands. Press and hold the button again,the digital display will shows the indication for power(H:200mW,U:100mW,L:25mW,-:OFF) press the button can select the power. Finally, press and hold the button,the red dot on the right bottom of the digital display will disappear.VTX is back to normal working state and the channel,band,power will display in turn on the digital display. 2. PWMSBUS/OSD setting When SBUSPWM port is connected with a RC receiver, it can been used to change transmitter parametersAV channels 1-8 and to shut transmitting by a RC( PITMODE in effect). Make sure that there is a SBUSPWM signal from receiver within 3 seconds after powering up ,otherwise the transmitter is back to button-press setting mode . When in the setting mode of SBUSPWM, the red dot on the digital display will glow. For Betaflight/Cleanflight OSD setting of power,bands,channels and Pitmode ,please referring to 'EWRF 5.8G AV TX OSD SettingBetaflight OSD setting of EWRF Transmitter'for details. Frequency(Mhz) Band CH1 CH2 CH3 CH4 CH 5 CH6 CH7 CH8 A 5865 5845 5825 5805 5785 5765 5745 5725 b 5733 5752 5771 5790 5809 5828 5847 5866 c 5705 5685 5665 5645 5885 5905 5925 5945 d 5740 5760 5780 5800 5820 5840 5860 5880 E 5658 5695 5732 5769 5806 5843 5880 5917 F 5362 5399 5436 5473 5510 5547 5584 5621 Note: 1.Make sure that there is enough space for airflow when installing the module on the drone in case the overheating protection starts to reduce the power even to shut down at the worst. 2. Please install the antenna before powering up for a longer use life. 3. .The maximum current of output DC 5V is 300mA. Package Included 1 x EWRF e7092TM Transmitter Module