Meco Minimumrc Fokker E3 420mm Wingspan Balsa Wood Laser Cut Rc Airplane Kit

MinimumRC Fokker E3 420mm Wingspan Balsa Wood Laser Cut RC Airplane KIT Overview: The Fokker E.III was the main variant of the Eindecker (monoplane) fighter aircraft of World War I. It entered service on the Western Front in December 1915 and was also supplied to Austria-Hungary and Turkey. The E.III was basically an E.II fitted with larger, newly designed wings that had a slightly narrower chord of 1.80 meter (70-7/8 in) compared to 1.88 meter (74 in) on the earlier Eindeckers, going back to Fokker's original M.5 monoplane aircraft. The E.III retained the same 75 kW (100 hp) Oberursel U.I engine, and therefore also used the larger diameter "horseshoe" pattern cowling that also mandated the inclusion of the E.II's soffit-like extensions to the sides of the upper nose sheet metalwork, but had a larger 81 l (21.5 gal) drum-shaped main fuel tank just behind the cockpit, which increased the Eindecker's endurance to about 2 hours; an hour more than the E.II. Most E.IIIs were armed with a single 7.92 mm (.312 in) Spandau LMG 08 machine gun with 500 rounds of ammunition; however, after the failure of the twin-gun Fokker E.IV as a viable successor, some E.IIIs were fitted with twin guns. Specification: Brand Name: MinimumRC Item Name: Fokker E3 Type: KIT, KIT with motor(optional) Wingspan: 420mm Length: 380mm Material: 1mm Balsa wood + 1mm laminate Flying Weight: 25-30g Package Weight: About 160g Recommended Parts (Not Included): Motor: 716 coreless, Click Here Servo: 1.7g *2, Click Here Receiver: Micro 1s 3CH receiver, Click Here Transmitter: 2.4G 4CH, Click Here Battery: 1S 3.7V 150mAH 1.25 JST Note: The KIT verison doesn't include any electronic device. The KIT with motor version comes with a 716 coreless motor and a 138mm propeller. Please select the version you prefer. Install Manual, Click Here Package Included: 1x MinimumRC Fokker E3 420mm Balsa Wood Laser Cut RC Airplane KIT