Eachine1 Matek 8 Bit Ws2812b Rgb 5050 Highlight Led For Naze32 Cc3d

Matek 8 Bit WS2812B RGB 5050 Highlight LED for Naze32 CC3D Description: Brand Name:Matek Item Name:WS2812B RGB 5050 LED Voltage: about 5V Ports: Digital Size: 51x10 mm Platform: AVR, Arduino,Naze32 / CC3D Flight Control (need to brush CleanFlight) Features: Built-in controller chip, only need an IO port to control multiple LED Chip built-in shaping circuit,signal distortion is not cumulative, stable display Trichromatic 256 brightness adjustment, scan frequency is not less than 400Hz / S Serial connection-level interface, through a signal line to finish receiving and decoding data Both ends have interfaces (DIN DOUT) that can be cascaded Will show the flight control lock / unlock,left and right aileron, brake, throttle, alarm and other status. Note: If it is used for Naze32 or CC3D flight control,it need to brushed CleanFlight, and using PPM receivers. Used for CC3D flight controller,you should pay attention to the following points: -CC3D need to brushed CleanFlight firmware. -Using PPM / SBUS receiver, you don't use PWM receiver. -GND 5V DIN behind the lights should connected to CC3D fifth row - + S of the motor output side. -Choosing PPM receiver in the CF's assistant software configuration,then choose LED_STRIP options. -Finally into the CF assistant software LED Strip Page to setup various states. Package Included: 1x WS2812B RGB 5050 LED