Flf3_Evo_Brushed Flight Controller Built-In Flysky 6ch Ppm Receiver Afhds 2a For Qx95 Qx90 Qx90c

FLF3_EVO_BRUSHED Flight Controller Built-in Flysky 6CH PPM Receiver AFHDS 2A For Eachine QX95 QX90 QX90C Note: FLYSKY AFHDS 2A Manual This Flight Controller Upgrade to AFHDS 2A Mode, now it is not compatible with AFHDS transmitter. Description: Brand Name: Eachine Item Name: FLF3_EVO_BRUSHED Flight Controller Built-in Flysky Receiver Item NO.: QX958FL Dimension: 22mm*32.5mm Thickness: 1.2mm Weight: 3g Receiver: Flysky 6CH PPM Receiver (AFHDS 2A) Coreless motor plug: SH1.0 Firmware: SP RACING F3 EVO 1.13.0 Support work voltage: 3.6v~4.2v(1S Lipo battery) Features: 1.F3_EVO_Brush revision is out of the F3 EVO SP RACING is based on a SP RACING F3 EVO firmware 32 brush flight control. 2.Independent design of the circuit structure 3.Using STM32F303CCT6 + MPU6500, advanced hardware platform F3 guarantee more stable flight. 4.With a large and high quality current NMOS transistors, operating current of up to 10A or more. Each Brushed motor is equipped with freewheeling diodes. 5.Integrated 2.4G Flysky 6CH PPM receiver (AFHDS 2A). 6.With battery voltage detection and buzzer interface(solder pad) 7.LED_STRIP Function(solder pad) Connection diagram: Receiver configuration: Just Set Receiver mode to be RX_PPM Bind procedure: 1. Connect the battery to the flight controller while holding the binding button on the board, the Blue LED will blinking fast, this indicates the Receiver is in binding mode. Then release the binding button. 2. Turn on your radio and Set receiver mode to AFHDS 2A, then get your radio into binding mode. The blue LED on the flight controller will turning off for a second and then starting to blinking slowly, this indicates binding successfully. 3. Turn on your radio ,then Reconnect the flight controller and the battery ,the Blue LED on the flight controller board will getting to be solid ,this indicates connection is established with your transmitter. Package included: 1 x FLF3_EVO_BRUSHED Flight Controller