Meco Dc 12-36v 500w Brushless Motor Controller Driver Board With Hall

Performance parameters: 1, the working voltage: 12-36V 2, the working current: 15A 3, drive power: 500W(More than 60W must add heat sink) 4, speed control voltage: 0.1V-5V 5, the working temperature: -40 - 85 6, the working humidity: 90% RH 7, over-current protection: Yes 8, stall protection: Yes 9, direction control: Yes 10, enable control: Yes 11, speed signal: Yes The left side of the wiring method: Power end OUT VCC (connected to the power supply positive) GND (connected to the power supply negative) MC (connected to motor phase W) MB (connected to motor phase V) MA (connected to motor phase line U) The right side of the wiring method: Motor hall GND(Hall line negative) Hc (Hall line) Hb (Hall line) Ha (Hall line) 5V (Hall Line Positive) Control terminal SET GND: control terminal ground VR: speed control terminal 0-5V (corresponding to motor speed 10% - 100%) ZF: positive and negative rotate control (connect 5V or ground can change the direction of rotation of the motor) M: speed pulse output (depending on the number of motor poles per turn a week corresponding to the number of output pulse) EL: enable control terminal (5V or ground, normal operation connected to 5V, grounded motor stop) 5V: control terminal 5V Note: As the Hall motor manufacturers do different Hall line does not necessarily match the board with the line order, it need to adjust, please note that this, if the line sequence is wrong, then start is not normal, the current is large, or do not start and so on, forced to use will burn the drive board. Package included: 1 x DC 12-36V 500W Brushless Motor Controller Driver Board With Hall