Eachine1 3 Axis Stepper Motor Driver Board Controller Laser Board For Diy Laser Engraver

Description: 3Axis Stepper Motor Driver Board Controller Laser board For DIY Laser Engraver Software: Please try to use this software to run the device. https://www.dropbox.com/s/74vtmjfcsbbxxv1/Software%20%26%20Driver%20Solution.zip?dl=0 Specification: Interface:USB Size:80mm*77mm Power Requirement: higher than12V 2A Support Stepper Motor:Motor within 2A 2-phase 4-wire Input Voltage:7.5V-12V (the voltage will affect the laser effect)) Power Interface: DC5.5 - 2.1 (Inside is positive electrodes and ouside is negative electrodes) Feature: Expansion of functions: stop, pause, resume, fans, low light, external relay Fit for DIY desktop laser engraver,dispensing machines printer,plotter,tool CNC. 3-axis linkage, Y-axis dual interface, can drive a stepper motor within 2A 2-phase 4-wire MINI USB interfaces, 12V power supply, delivery lines. Send software. Technical support. Large MOS tube,onboard DC buck module, wire jump ADJ can adjust manually the laser voltage to control the laser power Note: Jumper inserted in ADJ, Regulate the voltage module can control the laser voltage 5V laser module group should wire into ADJ and regulate the output voltage of 5V or less to pick Laser Module The motor can not work hight than 2A, when the motor work for a long time in 1A to 2A please pay attention to heat Wiring instruction: Package included: 1X USB 3 Axis Stepper Motor Driver Board 1X USB Cable 2X 2P Dupont Lines 4X 4P Dupont Lines