Eachine 12x60 Inch 3D Red Carbon Fiber Vinyl Car Wrap Roll Film Sticker Decal

Description: 12x60 Inch 3D Red Carbon Fiber Vinyl Car Wrap Roll Film Sticker Decal Specification: Material: vinyl Color: Red Quantity: 1 Piece Surface finish: Carbon Fiber Size: 152x30cm / 60"x12" (Length x Wide) Temperature resistance: -30C to +130C Placement on Vehicle: Left, Right, Front, Rear Model: for sheet wrap cover window film roll Type: with air release channels, air bubble free MPN: car sticker carbon fiber vinyl Supper life time: Over 10 years indoor life, 3-5 years outdoor life Condition: Brand-new, unused, unopened, undamaged item in its original packaging Features: It is a self adhesive vinyl Material, its function is same as 3M carbon fiber vinyl, excellent quality. Self-adhesive backing with Air Release Channels (Bubble-Free). Can be re-lifted, repositioned, and it brings you fast and easy installation experience. Easily removable, and will NOT damage to your paint during or after installation. Completely waterproof, stain and UV resistant. Ultra thin for easy installation on curves and corners. It is widely used for Car, Laptop, Motor, trunk lids, Home Decoration, side pillars, Bike, Phone, etc. Paste instructions: [Dry paste method] applicable motorcycle sticker or small stickers [Dry paste method steps] Tools: clean cloth, scraper, credit card 1, Clean body paste location. You can use isopropyl alcohol or acetone to scrub, or also can use soapy water; after cleaning surface Volatilization then can paste. 2, In General, while stickers, while tools evenness. 3, If the car stickers are less than 10 cm length and width, you can put the sticker tear paste. 4, With a clean rag or scraping (such as phone cards or credit cards) in the film repeatedly forced to rub or scrape a few oblique; until no bubble, then ripped (transparent) transfer film; Proposal: Do not wash or exposure within 24 hours. [Wet paste method] applicable large automotive car stickers[recommend Double people Operation] [Wet paste method steps] Tools: watering can, a clean rag, scraper, utility knife, hairdryer 1, Clean the surface paste, sprayed water on the paste surface - Is mainly used to reduce the sticker viscosity, easy to adjust the position. 2, Determine the location of the need stickers, together with car stickers from right to left (or from the bottom to up) use rag pressed posted on the car, then while stickers, while flatten with a rag, 4, Timely adjusted, when determine the correct location. Repeatedly with a scraper scrape water and bubbles, scraped from right to left when using the scraper. 5, At the door, and sewn use Utility Knife cut open, 6, Try to make car stickers in the water dry, can moderate heating and drying with a hairdryer. Suggestion: Try not to exposure within 24 hours, do not wash within 48 hours Installation process: Clean vehicle body Remove part of the whole car stickers, according to the models may be Does not matter if the sticker fold, Slowly calibrating the blade,repeat proper stretching,hair dryer heating the operation Encountered arc, bend area with Special attention to corners, this it a hair dryer heating more difficult to stickers, it can test your patience Paste process Corners heating, proper stretching, scraper Calibrating Knife cut off the excess sticker Knife cut off the excess sticker Perfect technology Task completion